Titan Electrical Solutions
Outdoor electrics · Aberdare

Garden office electrical installation in Aberdare

Garden office electrics in Aberdare: SWA supply, sub-board, sockets, lighting and heating. Fully certified to BS 7671.

Aberdare sits inside the area we cover daily, so outdoor electrics here is routine work rather than a special trip. What we are really assessing is condition, not age. SWA buried at compliant depth matters; the date on the board does not, by itself. Around CF44 it is SWA buried at compliant depth that decides how long the visit takes. People often expect the worst outcome. In practice, most Aberdare visits of this kind end with a defined, limited piece of work. Anything else found on the day is raised with you before it is touched. Before booking anything for outdoor electrics, it is worth knowing which findings change the price and which do not.

  • Where the survey supports it: SWA armoured supply from house to office
  • One of the usual points: sub-board with own RCD protection
  • Fully certified + Part P notified. Older Aberdare stock shows it earlier than newer builds do.
  • Most Aberdare gardens need 10–25m of SWA buried. If it is not this, testing narrows it down quickly.
  • Older Aberdare cottages frequently lack RCD protection on any is one of the few things we would ask you to stop using until tested.

What's different about Aberdare

Where the survey supports it: most Aberdare gardens need 10–25m of SWA buried at 600mm — we trench, lay and back-fill as part of the install.

One of the usual points: older Aberdare cottages frequently lack RCD protection on any circuit, meaning a consumer unit upgrade is almost always the first remedial after an EICR — relevant because the supply to a separate building is treated as a "second installation" and needs robust earthing.

Where for ex-mining cottages in Trecynon and Cwmbach with original shows up, we test the neighbouring circuits too.

In Rhondda Cynon Taf County Borough Council housing of this age, SWA armoured supply from house to office accounts for a good share of cases.

How we'd do it

  1. 1
    Survey
    We cable route, sub-board position, load calc, and you keep a copy of what was found.
  2. 2
    Certify
    One of the usual points: BS 7671 cert + Part P notification.
  3. 3
    Trench & lay
    We sub-board, sockets, lighting, heating; anything borderline is flagged rather than buried.
  4. 4
    Install
    Very often — sub-board, sockets, lighting, heating.

Common questions

What happens if the fault does not show up on the day?

Intermittent faults get logged and monitored rather than declared fixed. We tell you plainly if it has not been reproduced.

Can you advise without doing the work?

Yes. Plenty of Aberdare visits end with advice and no invoice for work that is not needed yet.

Do I need to be there for the whole visit?

Only for access and for the walk-through at the end. Most owners in Aberdare leave us to it once circuits are identified.

How far in advance should I book?

For non-urgent work, a week or so gives the most choice of slots across CF44.

Do you cover Aberdare for outdoor electrics?

Common around CF44 — yes — Aberdare and the surrounding CF44 postcodes are part of our regular working area, including Merthyr Tydfil and Mountain Ash, and Rhondda Cynon Taf County Borough Council notification is handled by us where the work requires it.

Can you give a price over the phone?

A realistic range, yes. A firm figure follows the testing, because sockets, lighting, heating, data and a simpler cause look identical from the outside.

We would rather answer a question than sell you a visit you do not need. Ask first. We cover Aberdare and the CF44 postcodes, including Mountain Ash, for outdoor electrics. Tell us what document you have been asked for and by whom, and we will confirm exactly which one applies. We cover Aberdare and the CF44 postcodes, including Pontypridd, for outdoor electrics.