Titan Electrical Solutions
Lighting design · Bridgend

Security and PIR lighting — design and install across Bridgend

For Bridgend owners and landlords: security and pir lighting, carried out to BS 7671 and written up properly. Covers security and pir lighting across Bridgend and the surrounding CF31–CF35 postcodes.

Talk through your lighting

Security and pir lighting touches safety, paperwork and cost, and the three do not always point the same way.

A light that comes on for every passing cat gets ignored, and an ignored light provides no security at all. We work to the current edition of BS 7671 and note where an older installation departs from it and why that matters. Around CF31–CF35 it is weatherproof enclosures and glanding appropriate that decides how long the visit takes.

People often expect the worst outcome. In practice, most Bridgend visits of this kind end with a defined, limited piece of work. Anything else found on the day is raised with you before it is touched.

Photographs of anything hidden are taken as standard, because you should not have to take our word for what is above the ceiling. It is one reason we quote after the survey rather than over the phone.

Every circuit affected is identified and labelled, which makes the next person's job — and yours — considerably easier. In practice that means checking very high output floodlights creating before anything is replaced.

The regulations change; the approach of measuring before advising does not. The intention of this page is to save you a wasted visit, not to create one.

Very high output floodlights creating glare and deeper shadow. Left alone it tends to widen rather than settle.

Landlords and owner-occupiers in Bridgend both see sensors mounted where passing traffic or pets trigger them.

Light spill into a neighbour's bedroom window, particularly where the installation has been extended piecemeal.

We rCD-protected supply with accessible isolation for maintenance, and you keep a copy of what was found.

Included for every Bridgend job of this type: fittings aimed downward at approach routes, not horizontally across.

Across CF31–CF35 properties we PIR detection zones set to the actual path the same way every time.

Standard practice here: weatherproof enclosures and glanding appropriate to the mounting position.

Written for Bridgend property owners rather than as general advice.

Mistakes we get called in to correct

Sensors mounted where passing traffic or pets trigger them constantly. That is checked on every visit.
For post-war semis in Brackla and Wildmill especially — light spill into a neighbour's bedroom window, which turns a security measure into a dispute.

The design brief

The useful setup is moderate output, aimed downward at the approach rather than outward at the boundary, with sensor coverage tuned to the path people actually walk. A light that comes on for every passing cat gets ignored, and an ignored light provides no security at all.

Full Property Rewires project in Bridgend: exterior wall-mounted lighting on a coastal property, delivered on a post-war semis in Brackla and Wildmill address the Bridgend area — an ordinary day's work rather than a showcasecluster pendant lighting fitted in a renovated kitchen completed during a full property rewires job in Bridgend — Bridgend (CF31–CF35) — taken while testing was in progressTitan Electrical Solutions — full property rewires in Bridgend. bathroom electrical remodel with zone-compliant lighting on a post-war semis in Brackla and Wildmill home Bridgend — shown before remedial work started

What we specify

  • Weatherproof enclosures and glanding appropriate to the mounting position That is checked on every visit.
  • For post-war semis in Brackla and Wildmill especially — rCD-protected supply with accessible isolation for maintenance
  • Fittings aimed downward at approach routes, not horizontally across boundaries That detail is easy to verify.

The important part: sensor positioning matters more than fitting choice; we set and test the detection pattern on site rather than fitting and leaving.

Decisions worth making early

How bright?

Less than most people assume. Excessive output creates glare and contrast shadow that actively helps concealment.

Integrate with cameras?

If you have cameras, aim and colour temperature should suit the camera, not the eye — even illumination beats a bright hot spot for usable footage.

Installing in Bridgend

Bridgend's Brackla and Parc Derwen estates carry modern boards but often need SPD retrofits, while central Bridgend terraces still throw the classic RCD-nuisance-trip pattern — worth knowing before committing to a lighting scheme here.

Housing here is post-war semis in Brackla and Wildmill, and that shows in what we find.

If you are just outside Bridgend — Porthcawl, Maesteg, Pencoed — the same rates and response apply.

Lighting questions from Bridgend

Can you advise without doing the work?

Yes. Plenty of Bridgend visits end with advice and no invoice for work that is not needed yet.

What if I have had this looked at before?

Bring us the previous report if you have one. We test independently but it is useful to see what changed.

Who do I speak to on the day?

The electrician doing the work. There is no call centre between you and the person at the Bridgend property.

What happens if the fault does not show up on the day?

Intermittent faults get logged and monitored rather than declared fixed. We tell you plainly if it has not been reproduced.

Do you cover Bridgend for lighting work?

Yes — Bridgend, Porthcawl, Maesteg, Pencoed and the surrounding area. CF31–CF35 is covered on our standard rounds rather than treated as an out-of-area trip.

Get it looked at properly

Tell us the address, the property type and what prompted the enquiry. You will get a straight answer about whether this needs doing now. We hold Bridgend slots for security and pir lighting most weeks.

🔒 No spam. Fast response, 8am – 9pm 7 days a week.