Next-day booking

Swansea: how we fix immersion heater not heating

We do not upsell a full replacement where a component is at fault, and we do not patch something that has reached the end of its life. It rarely changes the price, but it does change the plan.

Before booking immersion heater not heating anywhere in Swansea Council, it is worth knowing which parts of the job are fixed and which depend on your property. We serve Swansea and the surrounding SA1–SA7 area with same-day or next-day diagnostic visits and a fixed-price fix at the end of it. Most enquiries reaching us from Swansea arrive after something has already been tried. Starting from measurements rather than the previous attempt saves time. In practice that means checking immersion heater not heating before anything is replaced.

Book a diagnostic visit at your convenience. A quote that arrives before any testing is a guess with a number on it. We do it the other way round. It is written into the report either way, so nothing is hidden. Immersion heater not heating is worth doing properly once rather than cheaply twice.

Likely causes

The immersion thermostat has tripped its manual reset button after an overheat event.
The element itself has failed — very common after 8–10 years of use.
The switched fused spur feeding the immersion has a blown 13A fuse or failed switch.
The timer or off-peak controller has lost its schedule after a power cut.

How we fix it

We isolate at the spur, test the element for continuity and insulation, and replace element or thermostat as needed. Where the spur switch itself has failed we replace it — that's a common failure point often missed.

Typical price: £95–£160 for element or thermostat replacement.

When to stop and call

If the spur is on, the timer is scheduled correctly and the tank is stone cold after 2 hours.

Safe checks you can do first

Check the switched fused spur is on and the neon (if fitted) is lit.
Check the timer/controller display for a reset flag after any recent power loss.
Feel the tank — cold top means element failure, cold bottom means thermostat fault.

FAQs — immersion heater not heating in Swansea

How long does an immersion element last?+

8–12 years in soft-water areas, 5–8 years in hard-water areas where limescale accelerates failure.

Is it worth repairing or replacing the tank?+

If the tank is 20+ years old and lagged with a foam jacket rather than sprayed insulation, replacement is usually the right call.

Swansea context

We would rather turn a Swansea job down than take on something we cannot certificate honestly. Anyone testing properly will reach the same conclusion.

Check availability for SA1–SA7 — Immersion heater not heating in Swansea

Give us a rough idea of the property size and age and we can be much more specific about scope. We cover Swansea and the SA1–SA7 postcodes, including Neath, for immersion heater not heating. Send the details and we will come back with what is involved, what it depends on, and the paperwork you would receive.

Call 07949 398 752 Request a quote

In summary

Immersion heater not heating across Swansea: honest scope, recorded results, certification on completion. The short version: get it measured, then decide. Everything else follows from the readings. Nothing about this needs to be stressful — it is a known process with a known output.