Titan Electrical Solutions
Commercial · CF31–CF35

Bridgend: electrical compliance for warehouses and light industrial units

For Bridgend owners and landlords: warehouses and light industrial units, carried out to BS 7671 and written up properly. Warehouses and light industrial units is booked for Bridgend properties on the same rounds as Porthcawl.

Request a site survey

warehouses, workshops, storage units and light industrial premises

07949 398752

Warehouses and light industrial units touches safety, paperwork and cost, and the three do not always point the same way.

The retrofit case is usually made on lighting levels as much as energy, because warehouse racking creates shadowing that older fittings handle badly. We work to the current edition of BS 7671 and note where an older installation departs from it and why that matters. Around CF31–CF35 it is machinery supplies added over that decides how long the visit takes.

People often expect the worst outcome. In practice, most Bridgend visits of this kind end with a defined, limited piece of work. Anything else found on the day is raised with you before it is touched.

Photographs of anything hidden are taken as standard, because you should not have to take our word for what is above the ceiling. It is one reason we quote after the survey rather than over the phone.

Every circuit affected is identified and labelled, which makes the next person's job — and yours — considerably easier. In practice that means checking machinery supplies added over before anything is replaced.

The regulations change; the approach of measuring before advising does not. The intention of this page is to save you a wasted visit, not to create one.

Damaged containment and trailing supplies in traffic routes where. Left alone it tends to widen rather than settle.

Landlords and owner-occupiers in Bridgend both see high-bay lighting with long warm-up, poor uniformity and expensive.

Machinery supplies added over the years with no updated, particularly where the installation has been extended piecemeal.

Properties handled by Bridgend County Borough Council building control show the same pattern: three-phase boards with unbalanced loading across phases.

We impact-resistant containment and correctly rated isolators at each machine, and you keep a copy of what was found.

Included for every Bridgend job of this type: load balancing across phases and updated distribution schedules.

Across CF31–CF35 properties we three-phase distribution, sub-mains and machinery supplies the same way every time.

Standard practice here: LED high-bay retrofit with lighting levels checked against.

We fixed wire testing across the unit with a phased and explain what the numbers mean for the property.

Context throughout is Bridgend: CF31–CF35, Bridgend County Borough Council.

consumer unit swap with clean cable dressing — full property rewires by Titan Electrical Solutions at a post-war semis in Brackla and Wildmill property in Bridgend (CF31–CF35) — Warehouses and light industrial units, Bridgend: shown before remedial work started
warehouses, workshops, storage units and light industrial premises

CF31–CF35 is covered on our standard rounds rather than treated as an out-of-area trip.

Porthcawl and Pencoed sit either side of our Bridgend route, so both are same-week bookable.

The Bridgend picture

Bridgend's commercial stock is spread across CF31–CF35 rather than one estate.

What tends to go wrong on these sites

Three-phase boards with unbalanced loading across phases. That is checked on every visit.
For post-war semis in Brackla and Wildmill especially — damaged containment and trailing supplies in traffic routes where forklifts operate.
High-bay lighting with long warm-up, poor uniformity and expensive lamp replacement at height. That detail is easy to verify.

The work this typically involves

  • Three-phase distribution, sub-mains and machinery supplies That is checked on every visit.
  • For post-war semis in Brackla and Wildmill especially — LED high-bay retrofit with lighting levels checked against the task, not just the fitting count
  • Fixed wire testing across the unit with a phased shutdown plan That detail is easy to verify.

The important part: industrial premises fall under the Electricity at Work Regulations 1989 and, where machinery is involved, the safe isolation arrangements matter as much as the wiring. Every machine supply we install gets an accessible, lockable means of isolation.

In plain terms: shutdowns are planned around production. We survey first, pre-build what can be pre-built, and keep the actual isolation window as short as the work genuinely requires.

Commercial questions we get asked

Can you advise without doing the work?

Yes. Plenty of Bridgend visits end with advice and no invoice for work that is not needed yet.

What if I have had this looked at before?

Bring us the previous report if you have one. We test independently but it is useful to see what changed.

Who do I speak to on the day?

The electrician doing the work. There is no call centre between you and the person at the Bridgend property.

What happens if the fault does not show up on the day?

Intermittent faults get logged and monitored rather than declared fixed. We tell you plainly if it has not been reproduced.

Who notifies building control?

We do, through Bridgend County Borough Council where the work is notifiable. It is included rather than charged as an extra.

For Bridgend owners and landlords: warehouses and light industrial units, carried out to BS 7671 and written up properly. Warehouses and light industrial units is booked for Bridgend properties on the same rounds as Porthcawl.

Get it looked at properly

Tell us the address, the property type and what prompted the enquiry. You will get a straight answer about whether this needs doing now. Warehouses and light industrial units enquiries from Bridgend and Porthcawl are answered the same day.

🔒 No spam. Fast response, 8am – 9pm 7 days a week.